Ford Ranger II (2006-2009) (near breakout to manifold absolute pressure sensor) wiring diagram
This page shows the only wiring diagram for the component.(near breakout to manifold absolute pressure sensor), which is found in the car Ford Ranger II (2006-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(near breakout to manifold absolute pressure sensor) wiring diagram (1 of 1)
BATTERY JUNCTION BOX (BJB) (LEFT REAR SIDE OF ENGINE COMPT)
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/BRN WIRE
BLU/GRN WIRE
BLU/RED WIRE
BRN/WHT WIRE
CRANKSHAFT POSITION (CKP) SENSOR (LOWER RIGHT FRONT OF ENGINE)
FUEL PUMP RELAY
FUSE 11
FUSE 21
FUSE 23
FUSE 39
FUSE 43
FUSE 44
GRN/BLU WIRE
GRN/BRN WIRE
GRN/VIO WIRE
GRY WIRE
GRY/RED WIRE
GRY/VIO WIRE
GRY/YEL WIRE
HOT AT ALL TIMES
HOT IN START OR RUN
KNOCK SENSOR (LEFT FRONT OF ENGINE)
NCA WIRE
PCM POWER DIODE
PCM POWER RELAY
SMART JUNCTION BOX (SJB) (RIGHT KICK PANEL)
TRANSMISSIONS SYSTEM
VIO WIRE
VIO/GRY WIRE
VIO/ORG WIRE
VIO/WHT WIRE
WHT WIRE
WHT/BRN WIRE
WHT/RED WIRE
YEL WIRE
YEL/ORG WIRE
YEL/VIO WIRE
Go to component -> Wiring diagram engine performance 2.3l (2 of 4) -> (NEAR BREAKOUT TO MANIFOLD ABSOLUTE PRESSURE SENSOR)
