Ford Ranger I (1998-2006) safety belt ind can+ wiring diagram
This page shows the only wiring diagram for the component.safety belt ind can+, which is found in the car Ford Ranger I (1998-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
safety belt ind can+ wiring diagram (1 of 1)
AIR BAG SLIDING CONTACT (AT BOTTOM OF STEERING COLUMN)
BLK WIRE
BLK/LT GRN WIRE
BLK/PNK WIRE
BLK/WHT WIRE
CAN (+)
COMPUTER DATA LINES SYSTEM
DOOR AJAR IND
DRIVER SAFETY BELT RETRACTOR PRETENSIONER
FUSE 10
FUSE 33
FUSE 7
GROUND
HEAD
HOT AT ALL TIMES
HOT IN START OR RUN
IGNITION KEY SWITCH
INSTRUMENT CLUSTER
LEFT FRONT DOOR AJAR SWITCH (AT REAR OF LEFT FRONT DOOR)
LOW CURRENT BOARD
LT BLU/PNK WIRE
LT BLU/RED WIRE
LT GRN WIRE
LT GRN/BLK WIRE
LT GRN/WHT WIRE
MAIN LIGHT SWITCH
MICROPROCESSOR
NCA WIRE
ORG/BLK WIRE
PARK OFF
PNK/LT GRN WIRE
RED WIRE
RED/YEL WIRE
RESTRAINTS CONTROL MODULE (UNDER FRONT OF CENTER CONSOLE)
SAFETY BELT IND CAN+
SMART JUNCTION BOX (SJB) (BEHIND RIGHT SIDE OF DASH)
SW IN
TONE SIG
VBATT
VPWR
WARNING CHIME
WHT WIRE
WHT/LT GRN WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Warning systems circuit -> SAFETY BELT IND CAN+
