Ford Focus II facelift (2007-2011) (manual transmission) output shaft speed (oss) sensor wiring diagram
This page shows the only wiring diagram for the component.(manual transmission) output shaft speed (oss) sensor, which is found in the car Ford Focus II facelift (2007-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(manual transmission) output shaft speed (oss) sensor wiring diagram (1 of 1)
A/C COMPRESSOR CLUTCH FIELD COIL
ACCESSORY PROTOCOL INTERFACE MODULE (APIM)
AMBIENT LIGHTING POWER MODULE POINT 2
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
AUDIO CONTROL MODULE (ACM)
BATTERY
BATTERY A/C JUNCTION CLUTCH BOX (BJB) DIODE (LEFT REAR CORNER OF ENGINE COMPT)
BLK WIRE
BLOWER MOTOR RESISTOR
BLU WIRE
BRAKE FLUID LEVEL SWITCH
ENGINE COOLING FAN MOTOR
FLOOR SHIFTER
GRN WIRE
HORN
HVAC MODULE
INSTRUMENT CLUSTER
LEFT FRONT FOG LAMP
LEFT FRONT LEFT FRONT PARK/TURN SIDE LAMP LAMP
LEFT FRONT STRUT TOWER)
LEFT HEADLAMP
MASS AIR FLOW/ INTAKE AIR TEMPERATURE (MAF/IAT) SENSOR
POWER POINT 1
POWERTRAIN CONTROL MODULE (PCM)
RIGHT FRONT FOG LAMP
RIGHT FRONT PARK/TURN LAMP
RIGHT FRONT SIDE LAMP
RIGHT HEADLAMP
VIO WIRE
W/O IVD W/ IVD 26 16
WHT WIRE
WINDSHIELD WASHER PUMP MOTOR
WINDSHIELD WIPER MOTOR
WIPER POWER RELAY
YEL WIRE
Go to component -> Ground distribution circuit (1 of 3) -> (MANUAL TRANSMISSION) OUTPUT SHAFT SPEED (OSS) SENSOR
