Ford Escape I facelift 2 (2007-2012) (engine control wiring harness, near breakout to output shaft Wiring diagram
This page shows the only wiring diagram for the component.(engine control wiring harness, near breakout to output shaft, which is found in the car Ford Escape I facelift 2 (2007-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram (engine control wiring harness, near breakout to output shaft (1 of 1)
BATTERY JUNCTION BOX (BJB) (LEFT FRONT OF ENGINE COMPT)
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLU WIRE
BLU/GRN WIRE
BLU/GRY WIRE
BRAKE PEDAL POSITION SWITCH (LEFT SIDE OF DASH)
BRN/BLU WIRE
BRN/GRN WIRE
BRN/WHT WIRE
BRN/YEL WIRE
EARLY PRODUCTION
FPC
FPM
FPPWR
FPRTN
FUEL INJECTOR RELAY
FUSE 22
FUSE 23
GRN WIRE
GRN/BLU WIRE
GRN/BRN WIRE
GRN/ORG WIRE
GRY/ORG WIRE
GRY/RED WIRE
GRY/VIO WIRE
GRY/YEL WIRE
HOT AT ALL TIMES
LPC VFS
MASS AIR FLOW/INTAKE AIR TEMPERATURE (MAF/IAT) SENSOR (REAR OF ENGINE)
NCA WIRE
OSS +
SOL PWR
SPEED SENSOR
SSE ON/OFF SOL
TCC VFS
TFT
TFT SIG RTN
TRANSMISSION
TRS
TRS/OSS GND
TRS/OSS PWR
TSS
TSS GND
TSS PWR
VIO WIRE
VIO/GRN WIRE
VIO/GRY WIRE
VIO/ORG WIRE
VIO/WHT WIRE
VPWR FUEL
WHT/BRN WIRE
WHT/ORG WIRE
YEL/GRY WIRE
YEL/RED WIRE
YEL/VIO WIRE
Go to component -> Wiring diagram engine performance 3.0l (2 of 5) -> (ENGINE CONTROL WIRING HARNESS, NEAR BREAKOUT TO OUTPUT SHAFT
