Dodge Nitro I (2006-2011) 2 1 backup lamp sig gnd wiring diagram
This page shows the only wiring diagram for the component.2 1 backup lamp sig gnd, which is found in the car Dodge Nitro I (2006-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
2 1 backup lamp sig gnd wiring diagram (1 of 1)
2 1 BACKUP LAMP SIG GND
34 35 CAN C BUS (+) CAN C BUS (-)
7-WAY TRAILER TOW WIRING (CONNECTOR) (UNDER CENTER OF REAR BUMPER)
B(+)
BACKUP LAMP RELAY OUT
BACKUP LAMP SW SIG
BACKUP LAMP SWITCH (M/T) (TOP LEFT SIDE OF TRANSMISSION)
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
CAN C CAN C BUS (+) BUS (-)
COMPUTER DATA LINES SYSTEM
DK GRN/WHT WIRE
DK GRN/YEL WIRE
ELECTRONICS
HOT AT ALL TIMES
INSIDE REARVIEW MIRROR
LEFT TAIL LAMP ASSEMBLY BACKUP LAMP
POWERTRAIN CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
RIGHT TAIL LAMP ASSEMBLY BACKUP LAMP
TRANSMISSION RANGE SENSOR (RLE)
W/ HANDS FREE W/O HANDS FREE
WHT/BLK WIRE
WHT/LT BLU WIRE
WHT/LT GRN WIRE
Go to component -> Backup lamps circuit -> 2 1 BACKUP LAMP SIG GND
