Dodge Neon II (1999-2005) abs warning indicator Wiring diagram
This page shows the only wiring diagram for the component.abs warning indicator, which is found in the car Dodge Neon II (1999-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram abs warning indicator (1 of 1)
ABS INDICATOR CONTROL
ABS WARNING INDICATOR
BLK WIRE
BLU/RED WIRE
BRAKE LAMP SWITCH (TOP OF BRAKE PEDAL SUPPORT)
BRAKE LMP SW LR WHL SENS SIG
CONTROLLER ANTI-LOCK BRAKE (ON LEFT FRONT FRAME RAIL, BELOW MASTER CYLINDER)
DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH, NEAR KICK PANEL)
DK BLU WIRE
DK BLU/WHT (OR DK BLU/RED) WIRE
DK GRN WIRE
FUSE 10
FUSE 23
FUSE 4
FUSE 5
FUSE 8
FUSE BLOCK (ON LEFT SIDE OF DASH)
FUSED B (+)
FUSED B (+) IGN SW (START/RUN)
GROUND
HOT AT ALL TIMES
HOT IN RUN OR START
INSTRUMENT CLUSTER
LEFT FRONT WHEEL SPEED SENSOR (ON LEFT STEERING KNUCKLE)
LEFT REAR WHEEL SPEED SENSOR (ATTACHED TO LEFT DISC BRAKE ADAPTER)
LF WHL SENS SIG
LT GRN WIRE
LT GRN/DK BLU WIRE
PCI BUS
PCI BUS RF WHL SENS SIG
PNK WIRE
POWER DISTRIBUTION CENTER (ON LEFT SIDE OF ENGINE COMPT, NEAR BATTERY)
RED WIRE
RED/DK BLU WIRE
RED/DK GRN WIRE
RIGHT FRONT WHEEL SPEED SENSOR (ON RIGHT STEERING KNUCKLE)
RIGHT REAR WHEEL SPEED SENSOR (ATTACHED TO RIGHT DISC BRAKE ADAPTER)
TAN WIRE
VIO WIRE
VIO/YEL WIRE
WHT WIRE
WHT/DK BLU WIRE
WHT/TAN WIRE
YEL WIRE
YEL/DK BLU WIRE
Go to component -> Anti-lock brakes circuit -> ABS WARNING INDICATOR
