Dodge Magnum I facelift (2007-2008) front control module ign unlock (run- start) wiring diagram
This page shows the only wiring diagram for the component.front control module ign unlock (run- start), which is found in the car Dodge Magnum I facelift (2007-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
front control module ign unlock (run- start) wiring diagram (1 of 1)
20 27 ECT SIG SENSOR GND
3 19 28 ASD RLY CTRL ASD RELAY OUT ASD RELAY OUT
3.5L
AUTO SHUT DOWN RELAY
BLK/BRN WIRE
BRN/WHT WIRE
COMPUTER DATA LINES SYSTEM
DK BLU/DK GRN WIRE
ENGINE CONTROLS SYSTEM
ENGINE COOLANT TEMPERATURE SENSOR (3.5L: ON FRONT OF ENGINE)
FRONT CONTROL MODULE IGN UNLOCK (RUN- START)
FUSE 10
FUSE 11
FUSE 14
HOT AT ALL TIMES
HOT IN RUN OR START
HOT IN START
INTEGRATED POWER MODULE (AT RIGHT SIDE OF ENGINE COMPT)
IPM
PNK WIRE
PNK/GRY WIRE
POWER DISTRIBUTION CENTER (AT RIGHT REAR OF TRUNK) FUSE 29
POWERTRAIN CONTROL MODULE (AT RIGHT REAR OF ENGINE COMPT)
RED WIRE
VIO/ORG WIRE
WHT/LT BLU WIRE
WHT/LT GRN WIRE
YEL WIRE
Go to component -> A/t circuit, without autostick (1 of 2) -> FRONT CONTROL MODULE IGN UNLOCK (RUN- START)
