Dodge Magnum I (2003-2007) 20 27 ect sig sensor gnd Wiring diagram
This page shows the only wiring diagram for the component.20 27 ect sig sensor gnd, which is found in the car Dodge Magnum I (2003-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 20 27 ect sig sensor gnd (1 of 1)
20 27 ECT SIG SENSOR GND
3 19 28 AUTO SHT RLY ASD RELAY OUT ASD RELAY OUT
AUTO SHUTDOWN RELAY
BLK/BRN WIRE
BRN/GRY WIRE
BRN/WHT WIRE
COMPUTER DATA LINES SYSTEM
DATA LINK CONNECTOR (LOWER LEFT SIDE OF DASH)
DK BLU/DK GRN WIRE
ENGINE CONTROLS SYSTEM
ENGINE COOLANT TEMPERATURE SENSOR
FRONT CONTROL MODULE
FUSE 10
FUSE 11
FUSE 16 FUSE 14
HOT AT ALL TIMES
HOT IN RUN OR START
HOT IN START
INTEGRATED POWER MODULE (RIGHT SIDE OF ENGINE COMPT)
PDM
PNK WIRE
PNK/GRY WIRE
POWER DISTRIBUTION CENTER (RIGHT REAR OF TRUNK) FUSE 29
POWER DISTRIBUTION SYSTEM
POWERTRAIN CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
REAR OF ENGINE COMPT)
RED WIRE
VIO/ORG WIRE
WHT/BRN WIRE
WHT/DK GRN WIRE
WHT/LT BLU WIRE
WHT/LT GRN WIRE
YEL WIRE
Go to component -> A/t circuit, without autostick (1 of 2) -> 20 27 ECT SIG SENSOR GND
