Dodge Intrepid I (1992-1997) (near drl or drl jumper breakout) wiring diagram

1995 MODELS 1996 MODELS 1996 EAGLE MODELS W/AUTOSTICK ONLY 1996 MODELS 1995 MODELS 1996 MODELS ONLY 2-4 PRESS SWITCH OD PRESS SWITCH 2-4 SOL CTRL LOW/REV SOL 3.3L 3.5L 58 59 60 VSS UD SOLENOID OD SOLENOID PNK WIRE 9 10 1996 MODELS 1995 MODELS BLK WIRE BLK/LT BLU WIRE BLK/RED WIRE BLK/YEL WIRE BLU WIRE BRN WIRE BRN/YEL WIRE CCD BUS (+) AUTO DN SW CKP SENSOR SIG CRANKSHAFT POSITION SENSOR (RIGHT REAR OF ENGINE) DK BLU WIRE DK BLU/BLK WIRE DK GRN WIRE FUSE 17 FUSE 6 FUSED B (+) GND GND (LEFT FRONT OF TRANS.) GRN WIRE HOT IN OFF, RUN, START HOT IN RUN JUNCTION BLOCK L-R PRESS SWITCH LOW/REV PRESS SENSOR GND INPUT SPD SNS GND TRANS TEMP LR SOL. 2-4 SOL. LT BLU WIRE LT BLU/DK BLU WIRE LT GRN WIRE LT GRN/BLK WIRE LT GRN/WHT WIRE MODELS OD SOL. UD SOL. ORG/ WIRE ORG/BLK WIRE ORG/DK BLU WIRE PNK 3 8 WIRE PNK WIRE PNK/LT BLU WIRE RED WIRE RED/BLK WIRE RED/WHT WIRE SCI RECEIVE 2-4 PRESS SW SENSOR GROUND SIGNAL TRANSMISSION CONTROL MODULE (AT LEFT FENDER SIDE SHIELD) TRANSMISSION SOLENOIDS, PRESSURE SWITCH ASSEMBLY (ON TRANSMISSION) TURBINE SPEED SENSOR (LEFT SIDE OF TRANS.) SIGNAL (+) VIO WIRE VIO/BRN WIRE VIO/WHT WIRE WHT WIRE WHT/BLK WIRE WHT/ORG WIRE YEL WIRE YEL/BLK WIRE YEL/DK GRN WIRE YEL/RED WIRE