Dodge Durango III (2010-2013) left rear blind spot sensor (left rear bumper) wiring diagram
This page shows the only wiring diagram for the component.left rear blind spot sensor (left rear bumper), which is found in the car Dodge Durango III (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
left rear blind spot sensor (left rear bumper) wiring diagram (1 of 1)
1 2 3 4 GND CAN BUS (+) BLIND CAN BUS (-) BLIND
10 9 8 7 6 5 4 3 2 1 IGNR
6 5 1 2 3 4 GND GND GND CAN BUS (+) BLIND CAN BUS (-) BLIND IGNR
BLIND SPOT MODULE (UNDER DRIVER'S SEAT)
BLK RED/ WIRE
BLK WIRE
CAN BUS (+) BLIND CAN BUS (-) BLIND GND
COMPUTER DATA LINES SYSTEM
FUSE
GND CAN BUS (+) IHS CAN BUS (-) IHS
GRY WIRE
GRY/LT BLU WIRE
HOT W/ RUN RELAY (ON PCB) ENERGIZED
IGNR
LEFT REAR BLIND SPOT SENSOR (LEFT REAR BUMPER)
PNK/YEL WIRE
POWER DISTRIBUTION SYSTEM
RED/BLK WIRE
RIGHT REAR BLIND SPOT SENSOR (RIGHT REAR BUMPER)
TOTALLY INTEGRATED POWER MODULE (RIGHT SIDE OF ENGINE COMPT)
VIO WIRE
VIO/WHT WIRE
WHT WIRE
WHT/GRY WIRE
WHT/ORG WIRE
Go to component -> Blind spot monitoring circuit -> LEFT REAR BLIND SPOT SENSOR (LEFT REAR BUMPER)
