Dodge Durango III (2010-2013) batt ctrl pre wiring diagram
This page shows the only wiring diagram for the component.batt ctrl pre, which is found in the car Dodge Durango III (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
batt ctrl pre wiring diagram (1 of 1)
BATT CTRL PRE
BLIND SPOT MODULE
BLK RED/ WIRE
BLK WIRE
BRN/ORG WIRE
CARGO LAMP
CIRCUIT BOARD
COMPASS A/C HEATER MODULE CONTROL
CONSOLE POWER OUTLET
FUSE
FUSE FUSE
HEADLAMP WASHER RELAY POWER DISTRIBUTION CENTER ASSEMBLY
HEATED SEATS MODULE (IF EQUIPPED)
LEFT FRONT LAMP ASSEMBLY (IF EQUIPPED)
LEFT REAR BLIND-SPOT SENSOR
LEFT REAR RIGHT REAR HEATED SEAT HEATED SEAT SWITCH SWITCH
OCCUPANT RESTRAINT CONTROLLER MODULE
PARK ASSIST MODULE
PNK/ YEL WIRE
PNK/VIO WIRE
PNK/YEL WIRE
REAR CAMERA/ LICENSE PLATE LAMP ASSEMBLY
RED/ BLK WIRE
RED/LT GRN WIRE
RELAY
RELAY (ON PCB)
RIGHT FRONT LAMP ASSEMBLY (IF EQUIPPED)
RIGHT REAR BLIND-SPOT SENSOR
RUN WIRE
STARTER RELAY
TOTALLY INTEGRATED POWER MODULE (LEFT SIDE OF ENGINE COMPT) BUS BAR
TTOW BATT PRK PRE 3
YEL PNK/ WIRE
Go to component -> Power distribution circuit (4 of 4) -> BATT CTRL PRE
