Dodge Durango II facelift (2006-2009) inhibit stop lamp relay wiring diagram
This page shows the only wiring diagram for the component.inhibit stop lamp relay, which is found in the car Dodge Durango II facelift (2006-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
inhibit stop lamp relay wiring diagram (1 of 1)
5.7L 3.7L/4.7L
9 8 CAN C BUS (-) CAN C BUS (+)
ANTI-LOCK BRAKES MODULE (LEFT FRONT OF ENGINE COMPT)
BLK/ORG WIRE
BRAKE LAMP SW OUT
BRAKE PROVISION MODULE
BRAKE SW 1 SIGNAL
CAN C BUS (+)
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
DK GRN/WHT WIRE
FRONT CONTROL MODULE (AT INTEGRATED POWER MODULE)
FUSE 25
FUSE 26
GRN WIRE
GRY WIRE
GRY/RED WIRE
HOT AT ALL TIMES
HOT IN
INHIBIT STOP LAMP RELAY
JUNCTION BLOCK (LEFT KICK PANEL)
LT BLU WIRE
PNK WIRE
POWER DISTRIBUTION CENTER (LEFT SIDE OF ENGINE COMPARTMENT)
POWERTRAIN CONTROL MODULE (RIGHT SIDE OF ENGINE COMPT)
RED WIRE
RLY CTRL
RUN WIRE
S/C BRAKE SW OUT
S/C SUPPLY
SPEED CONTROL SERVO (LEFT REAR OF ENGINE COMPT)
STOP LAMP SWITCH (LEFT SIDE OF DASH)
TAN WIRE
VIO/WHT WIRE
VIO/YEL WIRE
WHT WIRE
WHT/LT BLU WIRE
WHT/TAN WIRE
YEL WIRE
YEL/RED WIRE
Go to component -> Exterior lamps circuit (2 of 2) -> INHIBIT STOP LAMP RELAY
