Dodge Durango II facelift (2006-2009) dynamics sensor wiring diagram
This page shows the only wiring diagram for the component.dynamics sensor, which is found in the car Dodge Durango II facelift (2006-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
dynamics sensor wiring diagram (1 of 1)
AC DRIVER LINE 1
AC LINE 2
ANTI-LOCK BRAKES MODULE
BLK WIRE
BRN WIRE
COMPT)
DK GRN WIRE
DYNAMICS SENSOR
FROM FUSE 16 (DIAGRAM 1 OF 4)
FROM FUSE 26 (DIAGRAM 2 OF 4)
FROM FUSE 34 (DIAGRAM 2 OF 4)
FROM STARTER MOTOR RELAY (DIAGRAM 1 OF 4)
FUSED B (+)
FUSED IGN SW OUTPUT (START)
GROUND
GRY WIRE
HEADLAMP SWITCH PANEL LAMPS DRIVER
IGNITION SWITCH
INTEGRATED POWER MODULE (LEFT SIDE OF ENGINE
INVERTER ENABLE SWITCH
INVERTER INVERTER ENABLE SWITCH SWITCH
INVERTER MODULE
INVERTER STATUS INDICATOR
INVERTER SWITCH
IPM FRONT FUSED IGN SW OUTPUT (OFF-RUN- START) CONTROL MODULE
IPM IGN SW SENSE INPUT
JUNCTION BLOCK
LOCK OFF
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
ORG/BRN WIRE
PNK (LEFT SIDE OF DASH) WIRE
PNK PNK WIRE
PNK WIRE
POWER DISTRIBUTION CENTER (LEFT SIDE OF ENGINE COMPT)
POWERTRAIN CONTROL MODULE
RED WIRE
RUN WIRE
SIGNAL
STEERING ANGLE SENSOR
STOP LAMP INHIBIT RELAY
VIO WIRE
WIRELESS CONTROL MODULE
YEL WIRE
Go to component -> Power distribution circuit (4 of 4) -> DYNAMICS SENSOR
