Dodge Durango II (2003-2006) inside rearview mirror back- up lamp feed Wiring diagram
This page shows the only wiring diagram for the component.inside rearview mirror back- up lamp feed, which is found in the car Dodge Durango II (2003-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram inside rearview mirror back- up lamp feed (1 of 1)
24 PNK WIRE
3.7L
4.7L/5.7L
BACK UP LAMP
BACK-UP LAMP FEED
BLK WIRE
BLU WIRE
BRN WIRE
CAN C (+)
COMPUTER DATA LINES SYSTEM (NEAR BREAKOUT FOR AMBIENT AIR TEMPERATURE SENSOR)
DK GRN WIRE
FRONT CONTROL MODULE
FUSE 18
FUSE 19
FUSED IGN SW OUT (RUN-START)
GROUND
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
INSIDE REARVIEW MIRROR BACK- UP LAMP FEED
JUNCTION BLOCK (LEFT KICK PANEL)
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PDM
PNK WIRE
POWER DISTRIBUTION MODULE (LEFT SIDE OF ENGINE COMPARTMENT)
POWERTRAIN CONTROL MODULE (RIGHT SIDE OF ENGINE COMPT)
RED WIRE
REV SNS
RIGHT TURN/ TAIL/STOP LAMP LEFT TURN/ TAIL/STOP LAMP
TRAILER TOW 7-WAY WIRING (CENTER OF REAR BUMPER)
TRANSMISSION CONTROL RELAY (IN PDC)
TRANSMISSION SOLENOID/ TRS ASSEMBLY (4.7/5.7L) (5.7L: LEFT SIDE OF TRANSMISSION)
TRANSMISSIONS SYSTEM
VIO/GRY WIRE
WHT WIRE
WHT/LT BLU WIRE
YEL WIRE
YEL/ORG WIRE
YEL/RED WIRE
Go to component -> Back-up lamps circuit -> INSIDE REARVIEW MIRROR BACK- UP LAMP FEED
