Dodge Dakota II (1997-2004) (right front fender side shield) wiring diagram
This page shows the only wiring diagram for the component.(right front fender side shield), which is found in the car Dodge Dakota II (1997-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(right front fender side shield) wiring diagram (1 of 1)
ACCEL/ RESUME
BLK WIRE
BLK/LT BLU WIRE
BRAKE LAMP SWITCH (TOP OF BRAKE PEDAL)
CANCL
CLOCK- SPRING
COAST
CRUISE CONTROL LAMP CONTROL
CRUISE INDICATOR
DATALINK CONNECTOR (UNDER DASH, LEFT OF STEERING COLUMN)
DIAGNOSTIC JUNCTION PORT (UNDER DASH, RIGHT SIDE OF STEERING COLUMN)
DK BLU WIRE
DK BLU/RED WIRE
DUMP
FUSE 14
FUSED IGN
HOT IN RUN OR START
INSTRUMENT CLUSTER
JOINT CONNECTOR 3 (IN POWER DISTRIBUTION CENTER)
JUNCTION BLOCK (LEFT END OF DASH)
LEFT SPEED CONTROL SWITCH
LT BLU WIRE
LT GRN WIRE
LT GRN/RED WIRE
NCA WIRE
PCI BUS
POWERTRAIN CONTROL MODULE (RIGHT FRONT INNER FENDER)
PWR SUPPLY
RED WIRE
RED/LT GRN WIRE
RIGHT SPEED CONTROL SWITCH
SENSOR GND
SET-
SPEED SW SIG
TAN/RED WIRE
VACUUM
VACUUM SOL
VEHICLE SPEED CONTROL SERVO (RIGHT FRONT OF ENGINE COMPT)
VENT
VENT SOL
VIO WIRE
VIO/YEL WIRE
WHT WIRE
YEL WIRE
YEL/RED WIRE
Go to component -> Cruise control circuit -> (RIGHT FRONT FENDER SIDE SHIELD)
