Dodge Dakota II (1997-2004) powertrain control module (on right inner fender wiring diagram
This page shows the only wiring diagram for the component.powertrain control module (on right inner fender, which is found in the car Dodge Dakota II (1997-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
powertrain control module (on right inner fender wiring diagram (1 of 1)
2.5L 3.9L/4.7L
4.7L
A/T
BATTERY
BLK WIRE
BLK/WHT WIRE
BRN WIRE
CLUTCH INTERLOCK SWITCH (ON CLUTCH MASTER CYLINDER PUSH ROD)
CLUTCH INTERLOCK SWITCH JUMPER (LEFT SIDE OF DASH)
ENGINE GROUND
ENGINE STARTER MOTOR
ENGINE STARTER MOTOR RELAY
EXCEPT 4.7L
FUSE
FUSE 16 (ON LEFT INNER FENDER PANEL)
HD IN PL IN
IGNITION SWITCH
JOINT CONNECTOR NO. 2
JOINT CONNECTOR NO. 3
JUNCTION BLOCK (ON LEFT SIDE OF DASH) FUSE 12
LOCK
M/T
OFF
PANEL)
POWER DISTRIBUTION CENTER
POWERTRAIN CONTROL MODULE (ON RIGHT INNER FENDER
RED WIRE
RED/TAN WIRE
RED/YEL WIRE
RUN WIRE
TRANSMISSION RANGE SENSOR (LEFT SIDE OF TRANSMISSION)
TRANSMISSION SOLENOID/TRS ASSEMBLY (IN TRANSMISSION)
YEL WIRE
Go to component -> Starting circuit -> POWERTRAIN CONTROL MODULE (ON RIGHT INNER FENDER
