Dodge Dakota II (1997-2004) check gauges ind ctrl wiring diagram
This page shows the only wiring diagram for the component.check gauges ind ctrl, which is found in the car Dodge Dakota II (1997-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
check gauges ind ctrl wiring diagram (1 of 1)
"CHECK GAUGES" INDICATOR
2.5L/4.7L
AUTO SHUT DOWN RELAY
AUTOMATIC SHUT DOWN RELAY (IN POWER DISTRIBUTION CENTER)
BATT TEMP SENSOR SIG
BATTERY
BATTERY TEMPERATURE SENSOR (ATTACHED UNDER BATTERY)
BLK WIRE
BLK/GRY WIRE
BLK/LT BLU WIRE
BLU WIRE
CHECK GAUGES IND CTRL
DK BLU/WHT WIRE
DK GRN WIRE
DK GRN/ORG WIRE
ENGINE GROUND
FUSE 11
FUSE 2
FUSED B (+)
FUSIBLE LINK (NEAR BATTERY)
GENERATOR
GENERATOR FIELD
GENERATOR SOURCE
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN OR START JUNCTION BLOCK (ON LEFT END OF DASH) FUSE 14
INSTRUMENT CLUSTER
JOINT CONNECTOR NO. 1 (IN POWER DISTRIBUTION CENTER)
JOINT CONNECTOR NO. 2 (IN POWER DISTRIBUTION CENTER)
JOINT CONNECTOR NO. 3 (IN POWER DISTRIBUTION CENTER)
LEAK DETECTION PUMP (UNDER BATTERY TRAY, POWER DISTRIBUTION CENTER)
PNK/YEL WIRE
POWER DISTRIBUTION CENTER (ON LEFT INNER FENDER PANEL)
POWERTRAIN CONTROL MODULE (ON RIGHT INNER FENDER PANEL)
RED WIRE
RED/WHT WIRE
SENSOR GRD
STARTER MOTOR
TRANSMISSION CONTROL RELAY (IN POWER DISTRIBUTION CENTER)
VOLTS
WHT WIRE
WHT/DK BLU WIRE
Go to component -> Charging circuit -> CHECK GAUGES IND CTRL
