Dodge Dakota (1989-1994) rear wheel anti-lock brakes system Wiring diagram
This page shows the only wiring diagram for the component.rear wheel anti-lock brakes system, which is found in the car Dodge Dakota (1989-1994). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear wheel anti-lock brakes system (1 of 1)
ANTI-LOCK BRAKES SYSTEM
B/H CONN (PIN #41)
B/H CONN PIN 10
B/H CONN PIN 7
B/H CONN PIN 8
B/H CONN PIN 9
BLK WIRE
BRAKE SENSE
BRN/RED WIRE
CLOCKSPRING ASSEMBLY
CRUISE CONTROL SERVO (LEFT SIDE FENDER SHIELD)
CRUISE CONTROL SWITCH (IN STEERING WHEEL)
DK BLU/RED WIRE
DK BLU/WHT WIRE
FUSE 15
FUSE 7
FUSE BLOCK- I/P
HOT AT ALL TIMES
HOT IN RUN OR START
LEFT HEADLAMP GROUND (LEFT FENDER SHIELD)
LT GRN/RED WIRE
LTGRN/RED WIRE
NCA WIRE
OFF
PNK/DK BLU WIRE
POWERTRAIN CONTROL MODULE 2
REAR WHEEL ANTI-LOCK BRAKES SYSTEM
RESUME, ACC
SET RESUME VACUUM VENT
SET/COAST
STOP LAMP SWITCH (NEAR STEERING COLUMN SUPPORT)
TAN/RED WIRE
WARNING BUZZER KEY-IN HEADLAMP-ON SEAT BELT WARNING (IN FUSE BLOCK:I/P)
WHT WIRE
WHT/LT GRN WIRE
WHT/PNK WIRE
WHT/RED WIRE
WHT/TAN WIRE
YEL/RED WIRE
Go to component -> Cruise control circuit -> REAR WHEEL ANTI-LOCK BRAKES SYSTEM
