Dodge Challenger III facelift (2010-2014) drive train control relay wiring diagram
This page shows the only wiring diagram for the component.drive train control relay, which is found in the car Dodge Challenger III facelift (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
drive train control relay wiring diagram (1 of 1)
3.6L
ANTI-LOCK BRAKES MODULE
BLK/RED WIRE
BUS BAR
CIRCUIT BOARD
CIRCUIT BRAKER 12
DIODE 2
DRIVE TRAIN CONTROL RELAY
DRIVER DOOR MODULE
FROM FUSE 1 (DIAGRAM 1 OF 4)
FROM FUSE 27 (DIAGRAM 3 OF 4)
FROM FUSE 30 (DIAGRAM 1 OF 4)
FUSE
FUSE 20
FUSE 28
FUSE 29
FUSE 40
GRY/ PNK WIRE
INSIDE REARVIEW MIRROR
LEFT HEATED SEAT SWITCH
LT GRN PNK/ WIRE
MIRROR SWITCH TIRE PRESSURE MODULE
NCA WIRE
PASSENGER DOOR MODULE
PNK/ GRY WIRE
PNK/ LT GRN WIRE
PNK/GRY WIRE
PNK/LT GRN WIRE
PNK/ORG WIRE
POWER STEERING PUMP MOTOR (IF EQUIPPED)
POWERTRAIN CONTROL MODULE
REAR OF ENGINE COMPT)
RED WIRE
RED/GRY WIRE
RED/ORG WIRE
RIGHT
RUN/START RELAY
STEERING CONTROL MODULE
STOP LAMP SWITCH
TOTALLY INTEGRATED POWER MODULE (RIGHT SIDE OF ENGINE COMPT)
UPPER HEATED BANK SEAT SWITCH CLUSTER SWITCH (6.4L)
ZENER DIODE
Go to component -> Power distribution circuit (4 of 4) -> DRIVE TRAIN CONTROL RELAY
