Dodge Challenger III (2008-2010) transmission temperature sensor wiring diagram
This page shows the only wiring diagram for the component.transmission temperature sensor, which is found in the car Dodge Challenger III (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transmission temperature sensor wiring diagram (1 of 1)
1-2/ 4-5 SOL
2-3 SOL
3-4 SOL
BLK/GRY WIRE
BLK/ORG WIRE
BRN/YEL WIRE
BTSI CTRL
CAN C BUS (+)
COMPUTER DATA LINES SYSTEM
DK GRN/ORG WIRE
DK GRN/VIO WIRE
ELECTROHYDRAULIC CONTROL UNIT ASSEMBLY (RIGHT SIDE OF TRANSMISSION)
ELECTRONICS
ENGINE COMPT)
FUSE 37
FUSED B (+)
HOT AT ALL TIMES
HOT IN RUN OR START
IGN UNLOCK-RUN-
MOD PRES CTRL SHIFT PRES CTRL SOL SPLY VOLT CAN C BUS (+) CAN C BUS (-)
MOD SHIFT PRESS PRESS SOL SOL
ORG/GRY WIRE
PNK WIRE
PNK/BLK WIRE
PNK/YEL WIRE
POWER DISTRIBUTION CENTER (RIGHT REAR OF TRUNK)
RLY OUT GROUND
SHIFTER LEVER ASSEMBLY
SPLY VOLT 1-2/4-5 CTRL 3-4 CTRL 2-3 CTRL TCC CTRL SENS GND P/N SIG
TCC SOL
TOTALLY INTEGRATED POWER MODULE (RIGHT SIDE OF
TRANSMISSION CONTROL MODULE (BELOW STEERING COLUMN)
TRANSMISSION RELAY
TRANSMISSION TEMPERATURE SENSOR
TRS PRK SIG
WHT/BLK WIRE
WHT/LT BLU WIRE
WIRELESS IGNITION NODE
YEL WIRE
YEL/BRN WIRE
YEL/DK BLU WIRE
YEL/GRY WIRE
YEL/LT BLU WIRE
YEL/LT GRN WIRE
YEL/ORG WIRE
YEL/TAN WIRE
Go to component -> Transmission circuit, 5 speed -> TRANSMISSION TEMPERATURE SENSOR
