Dodge Challenger III (2008-2010) ctrl output wiring diagram
This page shows the only wiring diagram for the component.ctrl output, which is found in the car Dodge Challenger III (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
ctrl output wiring diagram (1 of 1)
2/4 CTRL
2/4 L/R
2/4 PRESS SW
BLK/BRN WIRE
CTRL OUTPUT
DK BLU/DK GRN WIRE
DK GRN WIRE
DK GRN/BRN WIRE
DK GRN/DK BLU WIRE
DK GRN/LT BLU WIRE
DK GRN/ORG WIRE
DK GRN/TAN WIRE
DK GRN/VIO WIRE
DK GRN/WHT WIRE
DK GRN/YEL WIRE
FUSED B (+)
HOT AT ALL TIMES
INPUT SPEED SENSOR (RIGHT SIDE OF TRANSMISSION)
L/R CTRL LINE PRES CTRL GROUND GROUND GROUND
LINE PRES CTRL
LINE PRESS SIG
LINE PRESSURE SENSOR/ VARIABLE FORCE SOLENOID ASSEMBLY (REAR OF ENGINE COMPT)
LOW/REV PRESS SW
NOL
OD PRESS SIG
OD PRESS SW
OD UD SOL SOL SOL SOL
OUTPUT SPEED SENSOR (RIGHT SIDE OF TRANSMISSION)
POWERTRAIN CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
PRNL PN
SENS GND
TEMP SENS
TRANS CTRL OUT
TRANS RLY CTRL TRANS CTRL OUT
TRANSMISSION RANGE SENSOR (RIGHT SIDE OF TRANSMISSION)
TRANSMISSION SOLENOID/PRESSURE SWITCH ASSEMBLY (TOP OF TRANSMISSION)
YEL/BRN WIRE
YEL/DK BLU WIRE
YEL/DK GRN WIRE
YEL/GRY WIRE
YEL/LT BLU WIRE
YEL/ORG WIRE
YEL/PNK WIRE
YEL/TAN WIRE
Go to component -> Wiring diagram engine performance 3.5l (5 of 5) -> CTRL OUTPUT
