Dodge Caliber I facelift (2009-2013) app sens wiring diagram
This page shows the only wiring diagram for the component.app sens, which is found in the car Dodge Caliber I facelift (2009-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
app sens wiring diagram (1 of 1)
-START) OUT (RUN
14 18 IN SPD SIG SENS GND
21 5 OUT SPD GND OUT SPD SIG
6 5 4 TP SIG 2 TP SIG 1 MTR NEG CTRL
6 5 CAN BUS (-) CAN BUS (+)
ACCELERATOR PEDAL POSITION SENSOR (TOP OF ACCELERATOR PEDAL BRACKET)
APP 1 SENS FD
APP 2 SNSE FD
APP SENS
APP SIG (1)
APP SIG (2)
BATT FD
BLK/VIO WIRE
BRAKE/
BRN WIRE
BRN/ORG WIRE
BRN/VIO WIRE
BRN/YEL WIRE
COMPUTER DATA LINES SYSTEM
DK BLU/GRY WIRE
DK BLU/LT GRN WIRE
DK GRN WIRE
DK GRN/BLK WIRE
DK GRN/BRN WIRE
DK GRN/TAN WIRE
DK GRN/WHT WIRE
FD CMBD
IGN SW
IN SPD SIG
INPUT SPEED SENSOR (CVT) (LEFT SIDE OF TRANSMISSION)
LT BLU/DK GRN WIRE
ORG/BRN WIRE
OUT SPD GND
OUT SPD SIG
OUTPUT SPEED SENSOR (CVT) (RIGHT SIDE OF TRANSMISSION)
PNK/GRY WIRE
PNK/YEL WIRE
RED WIRE
RTN
RTN 2
RTN APP SENS
SIG (1)
SIG (2)
SPD SENS
ST LP
STOP LAMP SWITCH (TOP OF BRAKE PEDAL ASSEMBLY)
TAN DK GRN/ WIRE
TAN/DK GRN WIRE
THROTTLE BODY (LEFT SIDE OF ENGINE)
TP SENS RTN MTR POS CTRL
TRANSMISSION CONTROL MODULE (CVT) (BEHIND LEFT SIDE OF DASH)
TRANSMISSION RANGE SENSOR (CVT)
TRANSMISSIONS SYSTEM
VIO/BRN WIRE
WHT/BLK WIRE
WHT/BRN WIRE
WHT/LT BLU WIRE
YEL/BLK WIRE
YEL/ORG WIRE
Go to component -> Cruise control circuit (2 of 2) -> APP SENS
