Dodge Cab & Chassis R2500 (1996-2006) condensor fan control output wiring diagram
This page shows the only wiring diagram for the component.condensor fan control output, which is found in the car Dodge Cab & Chassis R2500 (1996-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
condensor fan control output wiring diagram (1 of 1)
5 VOLT SUPPLY
A/C CLUTCH CTRL
A/C COMPRESSOR CLUTCH (FRONT OF A/C COMPRESSOR)
A/C PRESS SIG
A/C PRESSURE SIGNAL
A/C PRESSURE TRANSDUCER
B(+) A/C PRESSURE GROUND
BLK WIRE
BLK/GRY WIRE
BLK/LT BLU WIRE
BRN WIRE
BRN/YEL WIRE
CONDENSER FAN MOTOR (GAS) (LEFT FRONT OF ENGINE COMPT)
CONDENSOR FAN CONTROL OUTPUT
DIESEL
DIESEL/ NGC
DK BLU/DK GRN WIRE
DK BLU/YEL WIRE
DK GRN WIRE
ECT SIG
ELECTRONICS
ENGINE CONTROL MODULE (DIESEL) (LOWER LEFT FRONT OF ENGINE BLOCK)
ENGINE COOLANT TEMPERATURE SENSOR (DIESEL)
EXCEPT SRT-10
EXCEPT SRT-10 SRT-10
GAS
HOT AT ALL TIMES
LT BLU WIRE
LT BLU/BRN WIRE
LT BLU/ORG WIRE
OF ENGINE)
ORG/ WIRE
POWERTRAIN CONTROL MODULE (RIGHT REAR OF ENGINE COMPARTMENT)
RELAY CONTROL
SENS GND
SENSOR GND
SIGNAL
SRT-10
TOTALLY INTEGRATED POWER MODULE (AT LEFT FRONT FENDER)
VIO/ORG WIRE
WHT WIRE
YEL/PNK WIRE
Go to component -> Manual a/c circuit (2 of 2) -> CONDENSOR FAN CONTROL OUTPUT
