Dodge Avenger II facelift (2011-2014) (top of accelerator pedal) wiring diagram
This page shows the only wiring diagram for the component.(top of accelerator pedal), which is found in the car Dodge Avenger II facelift (2011-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(top of accelerator pedal) wiring diagram (1 of 1)
6 5 4 TP SIG 2 TP SIG 1 MTR NEG CTRL
ACCELERATOR PEDAL POSITION SENSOR
APP SENS
APP SIG (1)
APP SIG (2)
APP SNSE FD 1
APP SNSE FD 2
BATT FD
BLK WIRE
BRAKE/
BRN/DK BLU WIRE
BRN/DK GRN WIRE
BRN/ORG WIRE
BRN/VIO WIRE
BRN/WHT WIRE
BRN/YEL WIRE
CAN-BUS
CLUSTER
COMPUTER DATA LINES SYSTEM
DK BLU/GRY WIRE
DK BLU/LT GRN WIRE
DK GRN/BRN WIRE
DK GRN/LT GRN WIRE
DK GRN/ORG WIRE
DK GRN/VIO WIRE
DK GRN/WHT WIRE
ENG CTRL
FD CMBD
IGN RUN/START
INPUT SPEED SENSOR (TOP OF TRANSAXLE)
LIMITED, SXT
LT BLU/DK GRN WIRE
LX, SE 2.4L DOHC 2.4L PZEV
OUTPUT SPEED SENSOR (RIGHT SIDE OF TRANSAXLE CASE)
PNK/WHT WIRE
PNK/YEL WIRE
RED WIRE
RTN 2
RTN APP SENS
SIG (1)
SIG (2)
ST LP
STOP LAMP SWITCH (TOP OF BRAKE PEDAL)
THROTTLE BODY (TOP RIGHT SIDE OF ENGINE)
TP SENS RTN MTR POS CTRL
TRANSFER SPEED SENSOR (LIMITED, SXT) (RIGHT REAR OF TRANSAXLE)
VIO/BRN WIRE
WHT WIRE
WHT/BRN WIRE
WHT/ORG WIRE
Go to component -> 2.4l, cruise control circuit (2 of 2) -> (TOP OF ACCELERATOR PEDAL)
