Dodge Avenger II (2007-2010) indicator drivers wiring diagram
This page shows the only wiring diagram for the component.indicator drivers, which is found in the car Dodge Avenger II (2007-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
indicator drivers wiring diagram (1 of 1)
11 12 CAN B BUS (-) CAN B BUS (+)
4 2 1 3 IGN SW OUT (RUN-START) FUSED B(+) GND LIN BUS
B(+) FRONT FRONT WASHER WIPER
BLK WIRE
BRN WIRE
BRN/GRY WIRE
BRN/ORG WIRE
BRN/WHT WIRE
BRN/YEL WIRE
CAN B BUS BUS CTRL CTRL (-) (+)
CLUSTER
COMPUTER DATA LINES SYSTEM
ELECTRONICS
FUSE
HOT AT ALL TIMES
IGN SW FRONT OUT FUSE WIPER WIPER (RUN- SW SNS HI OUT LOW OUT START)
INDICATOR DRIVERS
LIN BUS
PNK/WHT WIRE
REAR FRONT CAN B WASHER
RED WIRE
TOTALLY INTEGRATED POWER MODULE (LEFT SIDE OF ENGINE COMPT)
WHT WIRE
WHT/DK GRN WIRE
WHT/ORG WIRE
WINDSHIELD WASHER PUMP (IN WASHER RESERVOIR)
WINDSHIELD WIPER MOTOR (LEFT REAR OF ENGINE COMPT)
WIPER/ WASHER SWITCH
Go to component -> Wiper/washer circuit -> INDICATOR DRIVERS
