Dodge Avenger I (1994-2000) dedicated fuse 4 wiring diagram
This page shows the only wiring diagram for the component.dedicated fuse 4, which is found in the car Dodge Avenger I (1994-2000). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
dedicated fuse 4 wiring diagram (1 of 1)
2.0L 2.5L
A-77
A-78
A/T
AUTO CRUISE CONTROL MAIN SWITCH
AUTO- CRUISE CONTROL RELAY (RIGHT SIDE OF FIRE- WALL)
AUTO-CRUISE CONTROL SWITCH
AUTO-CRUISE SERVO (RIGHT SIDE OF SAFETY WALL)
B-41
B-54
B-54 JUNCTION BLOCK (LEFT KICK PANEL)
B-63
BLK WIRE
BLK/GRN WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BLU/WHT WIRE
BRN/WHT WIRE
C-06
CANCEL ON OFF
CLOCK- SPRING
COAST SET
CRUISE INDIC
DATA LINK CONNECTOR (NEAR CENTER CONSOLE) B-30
DEDICATED FUSE 1
DEDICATED FUSE 4
EATX CONTROL MODULE (A/T) (BELOW CENTER CONSOLE)
ENGINE COMPARTMENT RELAY BOX
FUSE 8
FUSE BOX (ENGINE COMPT. RELAY BOX)
FUSIBLE LINK 3
GRN WIRE
GRN/WHT WIRE
GRY/BLU WIRE
HOT AT ALL TIMES
HOT IN ACC, RUN OR START
HOT IN PARK
IGNITION SWITCH
ILLUM
INDIC
INPUT SPEED SENSOR (LEFT FRONT OF TRANS.)
INSTRUMENT CLUSTER
J/C 1 (LEFT KICK PANEL)
J/C 2 (LEFT SIDE OF DASH)
J/C 3 (ENGINE COMPT. RELAY BOX)
J/C 4 (ENGINE COMPT. RELAY BOX)
JUNCTION BLOCK (BEHIND LEFT SIDE OF DASH)
LEFT
LOCK ON
LT GRN WIRE
LT GRN/RED WIRE
LT GRN/WHT WIRE
M/T
OFF ACCEL/ RESUME
ON OFF
ON OFF OFF
OUTPUT SPEED SENSOR (ON TRANSMISSION, AT LEFT OUTPUT SHAFT)
POWER DISTRIBUTION SYSTEM
POWERTRAIN CONTROL MODULE (LEFT SIDE OF ENGINE COMPT)
RED WIRE
RED/BLK WIRE
SIDE OF DASH)
STOP LAMP SWITCH (ON BRAKE PEDAL
TO INTERIOR LIGHTS SYSTEM
TRANSAXLE RANGE SENSOR (ON TOP OF TRANSMISSION)
VEHICLE SPEED SENSOR (DOHC M/T) (LEFT FRONT OF TRANS.)
WHT WIRE
WHT/GRN WIRE
WHT/YEL WIRE
YEL WIRE
YEL/WHT WIRE
Go to component -> Cruise control circuit -> DEDICATED FUSE 4
