Chrysler LHS II (1998-2001) sci receive 2-4 press sw Wiring diagram

2-4 PRESSURE SWITCH 2-4 SOL CTRL LOW/REV SOL. CTRL 2-4 SOLENOID BLK WIRE BLK/LT BLU WIRE BLK/PNK WIRE BLK/RED WIRE BODY CONTROL MODULE (AT LEFT END OF DASH, ATTACHED TO JUNCTION BLOCK) BRN WIRE DK BLU WIRE DK BLU/BLK WIRE DK GRN WIRE FUSE 1 FUSED (B+) GND VSS SIG UD SOLENOID CTRL OD SOLENOID CTRL HOT IN OFF, RUN OR START JUNCTION BLOCK LOW/ REVERSE PRESSURE SWITCH LOW/ REVERSE SOLENOID LOW/REV PRESS SENSOR GND INPUT SPD SNS SIG GND TRANS TEMP SIG LT BLU WIRE LT GRN WIRE LT GRN/BLK WIRE LT GRN/RED WIRE LT GRN/WHT WIRE ORG/ WIRE ORG/BLK WIRE ORG/DK BLU WIRE OUTPUT SHAFT SPEED SENSOR (ON LEFT SIDE OF TRANSAXLE CASE) OVER- DRIVE SOLENOID OVERDRIVE PRESSURE SWITCH PCI BUS PCI BUS AUTO STICK DN SW PNK WIRE PNK/LT BLU WIRE PNP SW SENSE RED WIRE RED/BLK WIRE RED/LT BLU WIRE RED/WHT WIRE SCI RECEIVE 2-4 PRESS SW TRANSMISSION CONTROL MODULE (IN ENG COMPT, BETWEEN LEFT FRONT FENDER, BATTERY) TRANSMISSION SOLENOID, PRESSURE SWITCH ASSEMBLY (TRANSMISSION) TURBINE SPEED SENSOR (ON LEFT SIDE OF TRANSAXLE CASE) UNDER- DRIVE SOLENOID VIO WIRE VIO/PNK WIRE VIO/WHT WIRE WHT WIRE WHT/ORG WIRE WHT/RED WIRE YEL WIRE YEL/BLK WIRE YEL/DK GRN WIRE YEL/LT BLU WIRE YEL/VIO WIRE