Chrysler LHS II (1998-2001) ignition ground battery wiring diagram
This page shows the only wiring diagram for the component.ignition ground battery, which is found in the car Chrysler LHS II (1998-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
ignition ground battery wiring diagram (1 of 1)
BLK WIRE
BODY CONTROL MODULE (AT LEFT END OF DASH)
DK BLU WIRE
DK GRN WIRE
FUSE 17
FUSE 20
FUSE H
FUSE K
GROUND BATTERY LT REAR WHL SPD + LT FT WHL SPD - STOPLIGHT SW OUT
HOT AT ALL TIMES
HOT IN RUN
IGNITION GROUND BATTERY
JUNCTION BLOCK (LEFT END OF DASH)
LEFT FRONT WHEEL SPEED SENSOR (ON LEFT STEERING KNUCKLE BOSS)
LEFT REAR WHEEL SPEED SENSOR (ON LEFT REAR CALIPER ADAPTER)
LT GRN WIRE
LT GRN/DK BLU WIRE
PCI BUS
PNK WIRE
POWER DISTRIBUTION CENTER (ON LEFT SIDE OF ENGINE COMPT)
RED WIRE
RED/DK BLU WIRE
RED/DK GRN WIRE
RIGHT FRONT WHEEL SPEED SENSOR
RIGHT REAR WHEEL SPEED SENSOR
RT REAR WHL SPD + RT FT WHL SPD -
STOPLIGHT SWITCH (TOP OF BRAKE PEDAL)
TAN WIRE
VIO WIRE
WHT WIRE
WHT/DK BLU WIRE
WHT/TAN WIRE
WHT/VIO WIRE
YEL WIRE
YEL/DK BLU WIRE
YEL/VIO WIRE
Go to component -> Anti-lock brake circuits -> IGNITION GROUND BATTERY
