Chrysler Cirrus I (1994-2000) (engine harness, in breakout for generator) wiring diagram
This page shows the only wiring diagram for the component.(engine harness, in breakout for generator), which is found in the car Chrysler Cirrus I (1994-2000). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harness, in breakout for generator) wiring diagram (1 of 1)
1 11 CCD BUS (+) CCD BUS (-)
2.0L
2.4L/2.5L
2.5L 2.4L/2.0L ENGINE CONTROLS SYSTEM
4 3 CCD BUS (-) CCD BUS (+)
5 13 CCD BUS (+) CCD BUS (-)
AUTO- MATIC SHUT DOWN RELAY (IN PDC)
AUTOSTICK SWITCH
BAT- TERY
BLK WIRE
BLU WIRE
BODY CONTROL MODULE
BRN WIRE
CCD (+) BUS ASD RLY CTRL GEN FLD DVR
CCD BUS (-)
CHARGE WARNING LP CTRL
CHARGING SYSTEM WARNING LAMP
DK BLU/VIO WIRE
DK DK DK
DK GRN WIRE
DK GRN/ ORG WIRE
DK GRN/ORG WIRE
ENGINE CONTROLS SYSTEM
ENGINE STARTER MOTOR
FUSE 11
FUSE 5
FUSIBLE LINK
GENERATOR
GRN WIRE
HOT IN OFF, RUN OR START
IGN CCD BUS (-)
INSTRUMENT CLUSTER
JUNCTION BLOCK
LEFT STRUT TOWER)
NCA WIRE
ORG/ WIRE
POWER DIST- RIBUTION SYSTEM
POWER DISTRIBUTION CENTER
POWERTRAIN CONTROL MODULE (ATTACHED TO PDC)
RED WIRE
RED/TAN WIRE
RED/VIO WIRE
TAN WIRE
TRAVELER (RIGHT SIDE OF INSTRUMENT CLUSTER)
VIO WIRE
VIO/BRN WIRE
VIO/PNK WIRE
WHT WIRE
WHT/BLK WIRE
WHT/DK BLU WIRE
Go to component -> Charging circuit -> (ENGINE HARNESS, IN BREAKOUT FOR GENERATOR)
