Chrysler 200 I (2010-2014) (left side of transaxle) transmission solenoid/ pressure switch assembly wiring diagram
This page shows the only wiring diagram for the component.(left side of transaxle) transmission solenoid/ pressure switch assembly, which is found in the car Chrysler 200 I (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(left side of transaxle) transmission solenoid/ pressure switch assembly wiring diagram (1 of 1)
12 11 CAN BUS (+) CAN BUS (-)
16 40 ASTK UP ASTK DN
6 SPEED A/T
ASTK DN ASTK UP GND
BLK WIRE
BRK ACTV SENS SIG
BRK ACTV SNSE SIG
BRN/YEL WIRE
BTSI SOL 1 2 ULK GND
BTSI SOL ULK
CAN-BUS
CLUSTER
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
DK GRN WIRE
DK GRN/DK BLU WIRE
DK GRN/LT BLU WIRE
DK GRN/WHT WIRE
DK GRN/YEL WIRE
GRN WIRE
IOD FD
LT BLU WIRE
NCA WIRE
POWERTRAIN CONTROL MODULE (LEFT REAR OF ENGINE COMPT)
RED/GRY WIRE
SHIFT LEVER ASSEMBLY
STOP LAMP SWITCH (TOP OF BRAKE PEDAL)
TRANS RNG
TRANS RNG PRK/NEUT SIG
TRANSMISSION RANGE SENSOR
WHT WIRE
WHT/BLK WIRE
WHT/LT BLU WIRE
WHT/ORG WIRE
YEL WIRE
YEL/DK BLU WIRE
YEL/DK GRN WIRE
Go to component -> Shift interlock circuit, without dual clutch transmission -> (LEFT SIDE OF TRANSAXLE) TRANSMISSION SOLENOID/ PRESSURE SWITCH ASSEMBLY
