Chevrolet Venture I (1996-2005) seat belt sw signal Wiring diagram
This page shows the only wiring diagram for the component.seat belt sw signal, which is found in the car Chevrolet Venture I (1996-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram seat belt sw signal (1 of 1)
AMBIENT AIR TEMPERATURE SENSOR (ON FRONT RIGHT SIDE OF RADIATOR)
AMBIENT TEMP PWM DIMMING
BATTERY SERIAL DATA
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (BCM) (BELOW RIGHT SIDE OF DASH) SEAT BELT IND CNTL
BRN WIRE
COMPUTER DATA LINES SYSTEM
DK GRN/WHT WIRE
DRIVER INFORMATION CENTER
DRIVER SEAT BELT SWITCH (INSIDE RIGHT HALF OF DRIVER'S SEAT BELT)
DRL/HVAC/TEMP HTD ST FUSE
FUSE BLOCK (RIGHT SIDE OF DASH, IN RIGHT FRONT DOOR OPENING)
GRY WIRE
HOT AT ALL TIMES
HOT IN
IGNITION GROUND
LEFT FRONT DOOR LOCK SWITCH (AJAR IND SWITCH)
LEFT SLIDING DOOR JAMB SWITCH
LIFTGATE LOCK AJAR INDICATOR SWITCH (PART OF LIFTGATE LOCK ASSEMBLY)
LT GRN WIRE
LT GRN/BLK WIRE
NCA WIRE
ORG/ WIRE
PNK/BLK WIRE
RADIO FUSE
RIGHT FRONT DOOR LOCK SWITCH (AJAR IND SWITCH)
RIGHT SLIDING DOOR JAMB SWITCH
RUN WIRE
SEAT BELT SW SIGNAL
SUPPLEMENTAL RESTRAINTS SYSTEM
UNDERHOOD JUNCTION BLOCK (ON RIGHT FRONT OF ENGINE COMPT)
YEL WIRE
Go to component -> Instrument cluster circuit (2 of 2) -> SEAT BELT SW SIGNAL
