Chevrolet Venture I (1996-2005) ign main 1 wiring diagram
This page shows the only wiring diagram for the component.ign main 1, which is found in the car Chevrolet Venture I (1996-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
ign main 1 wiring diagram (1 of 1)
806 625 PPL IGNITION CRANK SENSE CRANK RELAY CONTROL
BATTERY
BLK WIRE
BULB TEST LOCK OFF
CLASS 2 SERIAL DATA LINE
CRANK
DATA LINK CONNECTOR (DLC) (PARTIAL) (BELOW STEERING COLUMN, ON KNEE BOLSTER)
DK GRN WIRE
FUSIBLE LINK A (10 GA- RUST)
FUSIBLE LINK C (14-GA
GENERATOR
GRY WIRE
HOLD- IN COIL
HOT AT ALL TIMES
HOT IN RUN, BULB TEST, START
I/P FUSE BLOCK (RIGHT SIDE OF DASH, IN RIGHT FRONT DOOR OPENING)
IGN MAIN 1
IGNITION SWITCH
PCM (CRANK) FUSE
PCM/ABS FUSE
PNK (ENG HARN, NEAR BREAKOUT FOR PCM) WIRE
PNK WIRE
POWER DISTRIBUTION SYSTEM
PPL
PULL- IN COIL
RED WIRE
RED/WHT WIRE
RUN WIRE
SPLICE PACK
STARTER MOTOR
STARTER RELAY
STARTER SOLENOID
UNDERHOOD FUSE BLOCK (IN ENGINE COMPT, FRONT OF RIGHT WHEELHOUSE ABOVE BATTERY)
YEL WIRE
YEL/BLK WIRE
Go to component -> Starting circuit -> IGN MAIN 1
