Chevrolet Venture I (1996-2005) driver seat belt input Wiring diagram

AIR BAG BLK WIRE BLK/WHT WIRE BODY CONTROL MODULE (BCM) (BELOW RIGHT SIDE OF DASH) BRN WIRE CASE GROUND DATA LINK CONNECTOR (DLC) (PARTIAL) (BELOW STEERING COLUMN, ON KNEE BOLSTER) PPL DK BLU WIRE DK GRN WIRE DRIVER SEAT ASSEMBLY DRIVER SEAT BELT INPUT DRIVER SEAT BELT SWITCH (OPEN WITH DRIVER SEAT BELT BUCKLED) GRY WIRE HIGH CONTROL LOW CONTROL LOW CONTROL HIGH CONTROL VOLTAGE SIGNAL SIGNAL VOLTAGE HOT IN RUN, BULB TEST, START I/P FUSE BLOCK (RIGHT SIDE OF DASH, IN RIGHT FRONT DOOR OPENING) INFLATABLE RESTRAINT I/P MODULE INFLATABLE RESTRAINT SENSING, DIAGNOSTIC MODULE (SDM) (BELOW RIGHT FRONT SEAT) INFLATABLE RESTRAINT STEERING WHEEL MODULE INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL INSTRUMENT PANEL CLUSTER (IPC) LEFT FRONT SEAT BELT PRETENSIONER LEFT SIDE IMPACT MODULE (ON LEFT SIDE OF DRIVER SEAT BACK COVER) LT BLU WIRE LT GRN WIRE NCA WIRE ORG/ WIRE ORG/BLK WIRE PNK WIRE PPL RIGHT FRONT SEAT BELT PRETENSIONER RIGHT SIDE IMPACT MODULE (ON RIGHT SIDE OF PASSENGER SEAT BACK COVER) SDM/SIR FUSE SEAT BELT SWITCH SHORTING BAR SOLID STATE SPLICE PACK TAN WIRE WHT WIRE YEL WIRE YEL/BLK WIRE