Chevrolet Uplander I (2004-2008) hold- in coil pull- in coil Wiring diagram

-HOOD AJAR -REMOTE START DISABLED -REMOTE START ON -SERVICE REMOTE BATT VOLT -STARTING DISABLE 12 VOLT REF 3.5L, 3.9L 3.9L 3.5L BATTERY BLK WIRE BLK/WHT WIRE BODY CONTROL MODULE (BCM) (BELOW LEFT SIDE OF DASH, LEFT OF STEERING COLUMN) CHARGING CIRCUIT CLASS 2 SERIAL DATA CLSTR/ HVAC FUSE 8 CRANK VOLTAGE CRNK RELAY DK GRN WIRE FUSIBLE LINK (8 GA- GROUND DISTRIBUTION SYSTEM GRY WIRE HOLD- IN COIL PULL- IN COIL HOOD AJAR SWITCH (UPPER CENTER OF RADIATOR SUPPORT, ON HOOD LATCH) HOOD AJAR SWITCH SIG HOT AT ALL TIMES HOT IN START OR RUN I/P FUSE BLOCK (RIGHT SIDE OF DASH, BEHIND ACCESS PANEL) IGNITION SWITCH INSTRUMENT PANEL CLUSTER LOCK LT GRN WIRE MESSAGE CENTER PNK IGNITION 1 VOLTAGE WIRE PNK WIRE PNK/BLK WIRE POWER DISTRIBUTION SYSTEM PPL PPL PPL RED WIRE RED/WHT WIRE RUN WIRE START ENABLE RLY CTRL STARTER MOTOR STRTR SOL FUSE 30 UNDERHOOD FUSE BLOCK (IN UNDERHOOD COMPT, ABOVE RIGHT FRONT WHEELWELL) W/ RKE WHT/BLK WIRE YEL WIRE YEL/BLK WIRE