Chevrolet Traverse I (2008-2012) headlamp high beam wiring diagram
This page shows the only wiring diagram for the component.headlamp high beam, which is found in the car Chevrolet Traverse I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
headlamp high beam wiring diagram (1 of 1)
A/C COMPRESSOR CLUTCH RELAY
AC CLTCH FUSE
AIR BAG FUSE
AUTOMATIC TRANSMISSION
AUX VAC PUMP FUSE
BANK 1 SENSOR 1
BANK 2 BANK 1 SENSOR 2 SENSOR 2
BLK WIRE
BRAKE BOOSTER PUMP RELAY
CONTROL SOLENOID VALVE ASSEMBLY
COOLING FAN SPEED CONTROL RELAY
ECM 1 FUSE
EMISSION 1 FUSE
EMISSION 2 FUSE
ENGINE CONTROL MODULE (ECM)
ENGINE FUEL PUMP CONTROL FLOW MODULE CONTROL (ECM) MODULE
EVEN COILS FUSE
EXCEPT CHEVROLET
FAN 1 FUSE
FAN-2 FUSE
FOG LAMP FUSE
FROM PWR OUTLET FUSE (DIAGRAM 2 OF 5)
FRONT FOG LAMP RELAY
HEADLAMP HIGH BEAM
HEADLAMP LOW BEAM
HEATED HEATED OXYGEN OXYGEN SENSOR SENSOR
HEATED OXYGEN SENSOR
HORN FUSE
HORN RELAY
I/P FUSE BLOCK (BEHIND RIGHT END OF DASH)
IGNITION COIL 1
IGNITION COIL 2
IGNITION IGNITION COIL 4 COIL 6
IGNITION IGNITION COIL 5 COIL 3
IGNITION MAIN RELAY
INFLATABLE RESTRAINT SENSING, DIAGNOSTIC MODULE (SDM)
INSTRUMENT INFLATABLE PANEL RESTRAINT CLUSTER I/P MODULE (IPC) INDICATOR
INTAKE CAMSHAFT POSITION (CMP) ACTUATOR SOLENOID VALVE BANK 1
INTAKE CAMSHAFT POSITION (CMP) ACTUATOR SOLENOID VALVE BANK 2
LEFT COOLING FAN HIGH SPEED RELAY
LEFT TRAILER STOP/TURN SIGNAL LAMP RELAY
MASS AIR FLOW (MAF)/ INTAKE AIR TEMPERATURE (IAT) SENSOR
NCA WIRE
ODD COILS FUSE
PARK LAMP RELAY
PCM IGN FUSE
PNK PNK WIRE
PNK WIRE
POWERTRAIN RELAY
REAR CAMERA FUSE
REAR WINDOW DEFOGGER RELAY
REARVIEW CAMERA (IF EQUIPPED)
RIGHT COOLING FAN HIGH SPEED RELAY
RIGHT TRAILER STOP/TURN SIGNAL LAMP RELAY
RR DEFOG FUSE
STARTER RELAY
STRTR FUSE
TO BODY CONTROL MODULE (BCM) (DIAGRAM 5 OF 5)
TRAILER BACKUP LAMP RELAY
TRANS FUSE
WHT WIRE
WINDSHIELD WIPER RELAY
WINDSHIELD WIPER SPEED CONTROL RELAY
WPR/ WSW FUSE
YEL WIRE
Go to component -> Power distribution circuit (3 of 5) -> HEADLAMP HIGH BEAM
