Car Wiring Diagrams for 2.5l vin 1, transfer case circuit for Chevrolet Tracker II (1998-2004)

1 28 29 GROUND GROUND DLC GND 28 29 2 7 9 13 35 34 8 25 B+ MIL CTRL MAIN RLY CTRL SERIAL DATA 2.5L 2.0L 4 15 20 20 21 3 IGN + IGN + IGN + 6 17 25 26 GROUND GROUND 7 27 18 15 18 11 AXLE CTRL HI AXLE CTRL LO PNK WIRE A/C SWITCH, MAIN CRUISE CONTROL SWITCH BLK WIRE BLK/BLU WIRE BLK/GRN WIRE BLK/ORG WIRE BLK/WHT WIRE BLU WIRE BLU/BLK WIRE DATA LINES SYSTEM DOME FUSE DRL MODULE, DATA LINK CONNECTOR, INSTRUMENT CLUSTER, RADIO ENGINE CONTROLS SYSTEM FOUR WHEEL DRIVE LOW SWITCH (TOP OF TRANSFER CASE) FOUR WHEEL DRIVE SWITCH (TOP OF TRANSFER CASE) FRONT DRIVE AXLE ACTUATOR PUMP FUEL PUMP RELAY FUSE FUSE BLOCK (ON RIGHT SIDE OF ENGINE COMPT, IN FRONT OF BATTERY) HOT AT ALL TIMES HOT IN ON OR START IG FUSE IGNITION COILS, GENERATOR (2.0L), NOISE SUPPRESSOR FILTER, HEATED OXYGEN SENSORS INSTRUMENT CLUSTER JUNCTION BLOCK (IN LEFT KICK PANEL) MAIN RELAY (BESIDE JUNCTION BLOCK) ORG/BLK WIRE ORG/WHT WIRE PNK WIRE POWERTRAIN CONTROL MODULE (UNDER RIGHT SIDE OF DASH) PPL/GRN WIRE PPL/YEL WIRE PRESSURE SWITCH RED WIRE RELAY (2.5L), GENERATOR (2.5L) RELEASE VALVE WHT WIRE