Car Wiring Diagrams for Cruise control circuit for Chevrolet Tracker II (1998-2004)

1.6L, 2.0L 2.5L A/T BLK WIRE BLK/RED WIRE BLK/WHT WIRE BLK/YEL WIRE BLU (OR BLK/RED) WIRE BLU WIRE BLU/BLK WIRE BLU/YEL WIRE CANCEL 910 OHM CLUTCH CONTROL RELEASE SWITCH CRUISE CONTROL MODE SWITCH CRUISE CONTROL SERVO (LEFT FRONT OF ENGINE COMPT, NEAR STRUT TOWER) CRUISE IND ENGINE CONTROL SYSTEM ENGINE CONTROLS SYSTEM FI FUSE FUSE BLOCK (RIGHT SIDE OF ENGINE COMPT IN FRONT OF BATTERY) GRN WIRE GRN/WHT WIRE GRY WIRE GRY/YEL WIRE HOT AT ALL TIMES HOT IN RUN, START IG FUSE INSTRUMENT CLUSTER INSTRUMENT CLUSTER SYSTEM JUNCTION BLOCK (IN LEFT KICK PANEL) LT GRN WIRE LT GRN/WHT WIRE M/T MAIN CRUISE CONTROL SWITCH MAIN RELAY (BESIDE JUNCTION BLOCK) MAIN RELAY CONTROL O/D CUT SIGNAL PNK/BLU WIRE POWERTRAIN CONTROL MODULE (UNDER RIGHT SIDE OF DASH) RED/GRN WIRE RED/YEL WIRE RES/ACC 230 OHM SET/COAST STARTER SOLENOID (RIGHT REAR SIDE OF ENGINE) STOP FUSE STOPLAMP SWITCH (ABOVE BRAKE PEDAL) T/P SIGNAL TRANSMISSION RANGE SWITCH (FRONT RIGHT SIDE OF TRANSMISSION) VEHICLE SPEED SENSOR (VSS) (RIGHT SIDE OF TRANSMISSION) WIPER/WASHER SWITCH YEL/GRN WIRE