Chevrolet Tracker II (1998-2004) cancel 910 ohm Wiring diagram
This page shows the only wiring diagram for the component.cancel 910 ohm, which is found in the car Chevrolet Tracker II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram cancel 910 ohm (1 of 1)
1.6L, 2.0L
2.5L
A/T
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU (OR BLK/RED) WIRE
BLU WIRE
BLU/BLK WIRE
BLU/YEL WIRE
CANCEL 910 OHM
CLUTCH CONTROL RELEASE SWITCH
CRUISE CONTROL MODE SWITCH
CRUISE CONTROL SERVO (LEFT FRONT OF ENGINE COMPT, NEAR STRUT TOWER)
CRUISE IND
ENGINE CONTROL SYSTEM
ENGINE CONTROLS SYSTEM
FI FUSE
FUSE BLOCK (RIGHT SIDE OF ENGINE COMPT IN FRONT OF BATTERY)
GRN WIRE
GRN/WHT WIRE
GRY WIRE
GRY/YEL WIRE
HOT AT ALL TIMES
HOT IN RUN, START
IG FUSE
INSTRUMENT CLUSTER
INSTRUMENT CLUSTER SYSTEM
JUNCTION BLOCK (IN LEFT KICK PANEL)
LT GRN WIRE
LT GRN/WHT WIRE
M/T
MAIN CRUISE CONTROL SWITCH
MAIN RELAY (BESIDE JUNCTION BLOCK)
MAIN RELAY CONTROL
O/D CUT SIGNAL
PNK/BLU WIRE
POWERTRAIN CONTROL MODULE (UNDER RIGHT SIDE OF DASH)
RED/GRN WIRE
RED/YEL WIRE
RES/ACC 230 OHM
SET/COAST
STARTER SOLENOID (RIGHT REAR SIDE OF ENGINE)
STOP FUSE
STOPLAMP SWITCH (ABOVE BRAKE PEDAL)
T/P SIGNAL
TRANSMISSION RANGE SWITCH (FRONT RIGHT SIDE OF TRANSMISSION)
VEHICLE SPEED SENSOR (VSS) (RIGHT SIDE OF TRANSMISSION)
WIPER/WASHER SWITCH
YEL/GRN WIRE
Go to component -> Cruise control circuit -> CANCEL 910 OHM
