Chevrolet Spark M300 (2009-2016) key capture solenoid actuator (on steering column) wiring diagram
This page shows the only wiring diagram for the component.key capture solenoid actuator (on steering column), which is found in the car Chevrolet Spark M300 (2009-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
key capture solenoid actuator (on steering column) wiring diagram (1 of 1)
13 7 SENSOR SPLY VOLT BRK APPLY SNSR SIG
15 7 OFF/RUN/CRANK VOLT ACCESSORY VOLTAGE
22 38 58 SENS LOW REF SENS SPLY VOL SNSR SIG
2500 2501 COMPUTER DATA LINES SYSTEM
29 43 SERIAL DATA(+) SERIAL DATA(-)
A/T M/T
BATTERY POS VOLT
BLK WIRE
BLK/BRN WIRE
BLU WIRE
BLU/YEL WIRE
BODY CONTROL MODULE (PASSENGER COMPT INSTRUMENT PANEL)
BRAKE PEDAL POSITION SENSOR (TOP OF BRAKE PEDAL ASSEMBLY)
COMPUTER DATA LINES SYSTEM
ENGINE CONTROL MODULE (ECM) (NEAR BATTERY)
GRN WIRE
HOT AT ALL TIMES DILS FUSE
IGNITION SWITCH
INSTRUMENT PANEL FUSE BLOCK (LEFT END OF DASH)
KEY CAPTURE SOLENOID ACTUATOR (ON STEERING COLUMN)
KEY-IN IGNITION SWITCH
OFF
PARK POSITION SWITCH
RED WIRE
RED/GRN WIRE
RED/WHT WIRE
RUN WIRE
SENSOR LOW REF
SERIAL DATA
TRANSMISSION SHIFT LEVER
VIO WIRE
VIO/YEL WIRE
WHT WIRE
WHT/VIO WIRE
Go to component -> Ignition lock solenoid circuit -> KEY CAPTURE SOLENOID ACTUATOR (ON STEERING COLUMN)
