Chevrolet Silverado GMT K2XX (2013-2015) w/o trailer brake control Wiring diagram
This page shows the only wiring diagram for the component.w/o trailer brake control, which is found in the car Chevrolet Silverado GMT K2XX (2013-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram w/o trailer brake control (1 of 1)
ANTI-LOCK BRAKES SYSTEM
BACKUP LAMPS CIRCUIT
BLK WIRE
BODY CONTROL MODULE (BCM) (LOWER LEFT SIDE OF DASH)
BRN WIRE
CAMPER TRAILER BLUNT CUTS
CUT)
DK BLU WIRE
DK GRN WIRE
EXTERIOR LIGHTS CIRCUIT
HOT AT ALL TIMES
HOT W/ BCK/UP LAMP RELAY ENERGIZED
HOT W/ PARK LAMP RELAY ENERGIZED
LEFT REAR FRAME RAIL) (31 SERIES: ON LEFT FRAME RAIL)
LT BLU/WHT WIRE
LT GRN WIRE
LT TRAILER TURN SIG LMP
ORG/ WIRE
POWER DISTRIBUTION SYSTEM
RED/BLK WIRE
RT TRAILER TURN SIG LMP
STUD 1 FUSE 68 FUSE 63
STUD 2 FUSE 63 FUSE 58
TRAILER BRAKE CONTROLLER SOLID STATE RELAY (20/30 SERIES:
TRAILER CONNECTOR (W/ TRUCK TRAILER WIRING HARNESS) (AT REAR OF VEHICLE)
TRAILER PROVISION (BLUNT
TRLR BCK/UP FUSE 10 FUSE 9
TRLR LT STOP/TURN PCB RELAY
TRLR PRK FUSE 25 FUSE 22
TRLR RT STOP/TURN PCB RELAY
TRLR STOP LT FUSE 3 FUSE 2
TRLR STOP RT FUSE 1 FUSE 4
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
W/O TRAILER BRAKE CONTROL
WHEEL TRAILER WIRING PROVISIONS, 97 DECIBELS ELECTRICAL BACKUP ALARM
WHT WIRE
YEL WIRE
Go to component -> Trailer tow circuit -> W/O TRAILER BRAKE CONTROL
