Chevrolet RV Cutaway G3500 (1997-2013) bank 1 sensor 1 (engine harness, appprox 12 cm from Wiring diagram
This page shows the only wiring diagram for the component.bank 1 sensor 1 (engine harness, appprox 12 cm from, which is found in the car Chevrolet RV Cutaway G3500 (1997-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram bank 1 sensor 1 (engine harness, appprox 12 cm from (1 of 1)
35 CM FROM 6-PIN CONNECTOR ON RIGHT FRAME RAIL)
4.3L (ENGINE HARNESS, APPROX 4 CM FROM FUEL INJECTOR HARNESS BREAKOUT)
5.0L, 5.7L, 7.4L
6.5L
7.4L
A/C COMPRESSOR ENABLE RELAY UNDERHOOD FUSE/RELAY CENTER
APPROX 66 CM FROM 6-PIN CONN ON RIGHT FRAME RAIL)
BANK 1 BANK 1 SENSOR 3 SENSOR 2
BANK 1 SENSOR 1
BANK 1 SENSOR 1 (ENGINE HARNESS, APPPROX 12 CM FROM
BANK 1 SENSOR 2
BANK 1 SENSOR 2 BANK 2 SENSOR 2
BANK 2 SENSOR 1
CRANKSHAFT POSITION (CKP) SENSOR
CRANKSHAFT POSITION (CKP) SENSOR HEATED OXYGEN SENSOR
DIESEL
ENG 1 FUSE
EVAPORATIVE EMISSION (EVAP) CANISTER PURGE VALVE SOLENOID
EVAPORATIVE EMISSION (EVAP) CANISTER VENT VALVE
EVAPORATIVE EMISSION (EVAP) CANISTER VENT VALVE MASS AIRFLOW (MAF) SENSOR
FROM IGNITION SWITCH (DIAGRAM 1 OF 4)
FUEL HEATER
FUEL INJECTORS 1, 3, 5, 7 VEHICLE CONTROL MODULE (VCM)
FUEL INJECTORS 2, 4, 6, 8 IGNITION CONTROL MODULE (ICM)
FUEL INJECTORS 2, 4, 6,, 8
FUEL SHUTOFF SOLENOID FUEL SOLENOID DRIVER
GLOW PLUG RELAY
HEATED OXYGEN HEATED OXYGEN SENSOR
HEATED OXYGEN SENSOR
HEATED OXYGEN SENSOR HEATED OXYGEN SENSOR
HEATED OXYGEN SENSOR MASS AIRFLOW (MAF) SENSOR
IGN 1 FUSE
IGN-E FUSE ECM-1 FUSE
IGNITION COIL
IGNITION CONTROL MODULE (ICM)
NCA WIRE
PNK WIRE
POWERTRAIN CONTROL MODULE (PCM)
TO I/P FUSE BLOCK (DIAGRAM 4 OF 4) PNK WIRE
UNDERHOOD FUSE/RELAY CENTER
UNDERHOOD FUSE/RELAY CENTER (CALIF ONLY)
WASTE GATE SOLENOID EPR SOLENOID
WATER IN-FUEL SENSOR
Go to component -> Power distribution circuit (3 of 4) -> BANK 1 SENSOR 1 (ENGINE HARNESS, APPPROX 12 CM FROM
