Chevrolet Prizm I (1997-2002) noise filter taped to engine accessory harness, near pcm) Wiring diagram
This page shows the only wiring diagram for the component.noise filter taped to engine accessory harness, near pcm), which is found in the car Chevrolet Prizm I (1997-2002). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram noise filter taped to engine accessory harness, near pcm) (1 of 1)
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BLU/YEL WIRE
BRN WIRE
CIG FUSE
DOME FUSE
FUSE, RELAY BLOCK 1 (LEFT FRONT OF ENGINE COMPT)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ACC, ON
HOT IN ON, START
ILLUM ILLUM
JUNCTION BLOCK 1 (BEHIND LEFT KICK PANEL)
JUNCTION BLOCK 2 (BEHIND LEFT SIDE OF DASH)
JUNCTION BLOCK 3 (BEHIND CENTER OF DASH)
LEFT FRONT SPEAKER
LEFT REAR SPEAKER
LR SPKR LR SPKR RF SPKR RF SPKR ILLUM
LT GRN WIRE
MULTI-FUNCTION ALARM MODULE
NCA WIRE
NOISE FILTER TAPED TO ENGINE ACCESSORY HARNESS, NEAR PCM)
PNK PPL LF SPKR LF SPKR RR SPKR RR SPKR GROUND BATTERY IGN WIRE
PNK WIRE
PPL
RADIO
RED WIRE
RIGHT FRONT SPEAKER
RIGHT REAR SPEAKER
WHT WIRE
WHT/GRN WIRE
YEL WIRE
Go to component -> Radio circuits -> NOISE FILTER TAPED TO ENGINE ACCESSORY HARNESS, NEAR PCM)
