Chevrolet Metro I (1997-2001) (engine harn, at pcm branch breakout) wiring diagram
This page shows the only wiring diagram for the component.(engine harn, at pcm branch breakout), which is found in the car Chevrolet Metro I (1997-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harn, at pcm branch breakout) wiring diagram (1 of 1)
A/C 2 RELAY (CONDENSER
A/C COMPRESSOR CONTROL MODULE
BATTERY
BLK WIRE
BLK/GRN WIRE
BLU WIRE
BRAID
BRAKE FLUID LEVEL SWITCH REAR WASHER PUMP
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR SHIELD
DAYTIME RUNNING LAMPS CONTROL MODULE
DISTRIBUTOR SHIELD
ELECTRONIC BRAKE CONTROL MODULE
ENGINE COOLING FAN MOTOR
FAN
FRONT WASHER PUMP
GRN WIRE
GROMMET, NEAR MASTER CYLINDER)
HEATED OXYGEN SENSOR 1 SHIELD
HEATED OXYGEN SENSOR 2 SHIELD
HORN
IDLE AIR CONTROL VALVE (VIN 9)
IDLE SPEED CONTROL MOTOR
IGNITION COIL NO 1 (VIN 9)
IGNITION COIL NO 2 (VIN 9)
JUNCTION BLOCK CONNECTOR
LEFT FRONT PARK/TURN LAMP LEFT PARKING LAMP
LIGHT 2 RELAY
POWERTRAIN CONTROL MODULE
RED WIRE
RELAY BOX
TO J/B (DIAGRAM 2 OF 3)
TURN LAMP CONNECTOR BREAKOUT)
VIN 9
W/ ABS
Go to component -> Ground distribution circuit (1 of 3) -> (ENGINE HARN, AT PCM BRANCH BREAKOUT)
