Chevrolet Malibu VIII (2011-2014) driver seat lumbar adjuster switch Wiring diagram
This page shows the only wiring diagram for the component.driver seat lumbar adjuster switch, which is found in the car Chevrolet Malibu VIII (2011-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram driver seat lumbar adjuster switch (1 of 1)
3 GND
AUTOMATIC TRANSMISSION SHIFT LEVER POSITION INDICATOR
BLK WIRE
BLU WIRE
BODY CONTROL MODULE (BCM)
CENTER CONSOLE FLOOD LAMP
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
DK DK
DOME/ READING LAMPS
DRIVER SEAT LUMBAR ADJUSTER SWITCH
FUEL/PMP RELAY 37
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
INSIDE REARVIEW MIRROR (ISRVM)
LEFT "C" PILLAR)
LEFT FRONT DOOR COURTESY LAMP
LEFT REAR MARKER LAMP
LEFT TAIL/STOP, TURN SIGNAL LAMP
LICENSE LAMP
NCA WIRE
ORG/ WIRE
OUTSIDE REARVIEW MIRROR SWITCH
R/WDO DEFOG RELAY 26
REAR COMPARTMENT LID LATCH
REAR FUSE BLOCK (LEFT SIDE OF TRUNK)
RIGHT LEFT BACKUP BACKUP LAMP LAMP
RIGHT REAR MARKER LAMP
RIGHT TAIL/STOP, TURN SIGNAL LAMP
W/ LZ OPTION PACKAGE-1 W/O LZ OPTION PACKAGE-1
W/ ONSTAR
W/O DRIVER FRONT SEAT ADJUSTER W/ DRIVER FRONT SEAT ADJUSTER
WHT WIRE
YEL WIRE
Go to component -> Ground distribution circuit (3 of 3) -> DRIVER SEAT LUMBAR ADJUSTER SWITCH
