Chevrolet Malibu VII (2008-2012) (engine harness, 90 mm from a/c compressor breakout) wiring diagram
This page shows the only wiring diagram for the component.(engine harness, 90 mm from a/c compressor breakout), which is found in the car Chevrolet Malibu VII (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harness, 90 mm from a/c compressor breakout) wiring diagram (1 of 1)
2.4L (VIN 5) 2.4L (VIN B), 3.6L
2.4L (VIN 5), 2.4L (VIN B) 3.6L 2.4L (VIN 5)
A/C COOL/FAN COMPRESSOR SER/PAR CLUTCH RELAY 29
BATTERY
BLK WIRE
BODY CONTROL MODULE (BCM)
BRAKE ELECTRONIC BRAKE FLUID CONTROL LEVEL MODULE (EBCM) SWITCH
ENGINE CONTROL MODULE (ECM)
GENERATOR BATTERY ASSEMBLY
HOOD AJAR SWITCH
HORN ASSEMBLY
LEFT FRONT MARKER LAMP
LEFT FRONT REPEATER LAMP
LEFT HIGH BEAM HEADLAMP
LEFT LOW BEAM HEADLAMP
LEFT PARK/TURN SIGNAL LAMP
MASS AIR FLOW (MAF)/ INTAKE AIR TEMPERATURE (IAT) SENSOR
NCA WIRE
RIGHT FRONT MARKER LAMP
RIGHT HIGH BEAM HEADLAMP
RIGHT LOW BEAM HEADLAMP
RIGHT PARK/TURN SIGNAL LAMP
RIGHT RIGHT ENGINE ENGINE COOLING COOLING FAN FAN
SECONDARY AIR INJECTION (AIR) PUMP DIODE
SECONDARY AIR INJECTION RUN/CRANK (AIR) RELAY 32 RELAY 31 PUMP
TRANSMISSION CONTROL MODULE (TCM)
WHT WIRE
WINDSHIELD WASHER FLUID LEVEL SWITCH
WINDSHIELD WASHER FLUID PUMP
WINDSHIELD WIPER MOTOR
WPR 2 WPR 1 RELAY 40
Go to component -> Ground distribution circuit (1 of 3) -> (ENGINE HARNESS, 90 MM FROM A/C COMPRESSOR BREAKOUT)
