Chevrolet Malibu VI facelift (2006-2008) solenoid valve control Wiring diagram
This page shows the only wiring diagram for the component.solenoid valve control, which is found in the car Chevrolet Malibu VI facelift (2006-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram solenoid valve control (1 of 1)
ABS FUSE 15
ABS FUSE 24
ABS IND.
BAT BAT IGN 1 VOLTAGE
BLK WIRE
BRAKE PRESSURE MODULATOR VALVE (BPMV)
BRN WIRE
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
ELECTRONIC BRAKE CONTROL MODULE (EBCM) (INSIDE LEFT FRONT FENDER)
HOT AT ALL TIMES
HOT IN RUN OR START
IGN
INSTRUMENT PANEL CLUSTER (IPC)
LEFT REAR WHEEL SPEED SENSOR (INSIDE WHEEL HUB)
LOGIC
LOW SPEED GMLAN
LOW SPEED GMLAN SERIAL DATA
LOW TRACTION IND
LR OUTLET
LT BLU WIRE
ORG/ WIRE
PNK WIRE
PUMP MOTOR
PUMP MOTOR CONTROL
RED/BLK WIRE
RIGHT REAR WHEEL SPEED SENSOR (INSIDE WHEEL HUB)
SER DATA
SERIAL DATA
SOLENOID VALVE
SOLENOID VALVE CONTROL
SOLENOID VALVE LF INLET
SOLENOID VALVE LF OUTLET
SOLENOID VALVE LR INLET
SOLENOID VALVE RF INLET
SOLENOID VALVE RF OUTLET
SOLENOID VALVE RR INLET
SOLENOID VALVE RR OUTLET
TAN WIRE
TAN/BLK WIRE
TRACTION OFF IND BRAKE IND
UNDERHOOD FUSE BLOCK (ON LEFT SIDE OF ENGINE COMPT)
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brakes circuit (1 of 2) -> SOLENOID VALVE CONTROL
