Chevrolet Malibu VI (2003-2006) stop lamp switch signal Wiring diagram
This page shows the only wiring diagram for the component.stop lamp switch signal, which is found in the car Chevrolet Malibu VI (2003-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram stop lamp switch signal (1 of 1)
5-VOLT REFERENCE
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (RIGHT END OF DASH)
BRAKE PEDAL POSITION SENS SIG
BRAKE PEDAL POSITION SENSOR (ON BRAKE PEDAL SUPPORT)
BRN WIRE
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL SWITCH SIGNAL
CRUISE INDICATOR
DK GRN WIRE
GMLAN
GROUND
GRY WIRE
GRY/BLK WIRE
GRY/WHT WIRE
HOT AT ALL TIMES
HOT W/ RUN/CRANK RELAY ENERGIZED
IBCM (R/C) FUSE 21
IBCM 2 FUSE 25
INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL
INSTRUMENT PANEL CLUSTER
INTERIOR LIGHTS FUSE 25
LEFT STEERING WHEEL CONTROLS
LOGIC
LOW REFERENCE
LOW SPEED GMLAN SERIAL DATA
PNK WIRE
POWERTRAIN CONTROL MODULE (AT FRONT OF BATTERY)
PPL
R/A
RED/BLK WIRE
RIGHT STEERING WHEEL CONTROLS
RUN/CRANK FUSE
S/C
STOP LAMP SWITCH SIGNAL
STP SIG
SWITCH SIGNAL
TAN WIRE
THROTTLE ACTUATOR CONTROL MODULE (ON INTAKE MANIFOLD)
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPARTMENT)
VSS SIG
W/ 2.2L W/ 3.5L
W/O ACCESSORY CONTROL STEERING WHEEL W/ ACCESSORY CONTROL STEERING WHEEL
WHT WIRE
YEL WIRE
Go to component -> Cruise control circuit -> STOP LAMP SWITCH SIGNAL
