Chevrolet Lumina I (1989-2001) cooling fan control relay 1 Wiring diagram
This page shows the only wiring diagram for the component.cooling fan control relay 1, which is found in the car Chevrolet Lumina I (1989-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram cooling fan control relay 1 (1 of 1)
A/C COMPRESSOR CLUTCH
A/C COMPRESSOR CLUTCH DIODE
A/C COMPRESSOR CLUTCH RELAY
A/C CONT FUSE
BLK WIRE
BRN WIRE
COOLING FAN CONTROL RELAY 1
COOLING FAN CONTROL RELAY 2
COOLING FAN CONTROL RELAY 3
DK BLU WIRE
DK GRN WIRE
DK GRN/WHT WIRE
ENGINE COOLANT FAN MOTOR 1
ENGINE COOLANT FAN MOTOR 2
ENGINE WIRING HARNESS JUNCTION BLOCK 1
ENGINE WIRING HARNESS JUNCTION BLOCK 2 (FORWARD OF LEFT FRONT STRUT POWER)
FAN 3 FUSE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
LEFT ELECTRIC ACTUATOR (BEHIND DASH, LEFT END OF HEATER-A/C MODULE)
LT BLU WIRE
LT GRN WIRE
MAXI FUSE 1
NCA WIRE
ORG/ WIRE
PCM BAT FUSE
PNK WIRE
RED WIRE
RELAY CONTROL A/C REQUEST SENSOR INPUT 22 26
RELAY CONTROL RELAY CONTROL SENSOR GROUND
RIGHT ELECTRIC ACTUATOR (BEHIND DASH, RIGHT END OF HEATER-A/C MODULE)
SOLID STATE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Manual a/c circuit, dual zone a/c (2 of 2) -> COOLING FAN CONTROL RELAY 1
