Chevrolet Impala VII (1994-1996) warning alarm seat belt input Wiring diagram
This page shows the only wiring diagram for the component.warning alarm seat belt input, which is found in the car Chevrolet Impala VII (1994-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram warning alarm seat belt input (1 of 1)
1995 VFTC
8.45
AIR BAG FUSE
BLK WIRE
BLK/WHT WIRE
BRN WIRE
COMPUTER DATA LINES
CONVENIENCE CENTER (BEHIND LEFT I/P, LEFT OF STEERING COLUMN)
CRANK FUSE
CRANK INPUT
DK GRN WIRE
DK GRN/WHT WIRE
DRIVER SEAT BELT IN
DRIVER SIDE "HIGH"
DRIVER SIDE "LOW"
GROUND
GRY WIRE
HOT IN
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK
I/P INDIC FUSE
IGN 1
IND
INFLATABLE RESTRAINT FRONT END SHEET METAL SENSOR (ON CENTER RADIATOR SUPPORT)
INFLATABLE RESTRAINT I/P INFLATOR MODULE (BELOW RIGHT I/P TOP COVER)
INFLATABLE RESTRAINT STEERING WHEEL INFLATOR MODULE
INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL (TOP OF STEERING COLUMN)
NCA WIRE
PASSENGER SIDE "HIGH"
PASSENGER SIDE "LOW"
PNK WIRE
PPL
REDUNDANT IND GROUND
REDUNDANT IND IGN 1
REFERENCE VOLTAGE
SEAT BELT SWITCH
SENSOR SIGNAL
SERIAL DATA LINE
SHORTING BAR
SIR IND
TAN WIRE
WARNING ALARM SEAT BELT INPUT
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Supplemental restraint circuit -> WARNING ALARM SEAT BELT INPUT
