Chevrolet Impala VII (1994-1996) control signals Wiring diagram
This page shows the only wiring diagram for the component.control signals, which is found in the car Chevrolet Impala VII (1994-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram control signals (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 GROUND BATTERY BATTERY IGNITION
18 19 REAR WHEEL SENSOR INPUT REAR WHEEL SENSOR GRD
1995 VFTC
ABS IND.
ANTI-LOCK INDICATOR CONTROL
BLK WIRE
BLK/WHT WIRE
BRAKE APPLIED SIGNAL SERIAL DATA LINE
BRAKE PRESSURE MODULATOR VALVE (BPM)
BRN WIRE
CHEVROLET BUICK
CONTROL SIGNALS
DATA LINK CONN (DLC) (ATTACHED TO I/P CARRIER, RIGHT OF STEERING COLUMN)
DK GRN WIRE
ELECTRONIC BRAKE CONTROL MODULE (EBCM) ( LEFT FRONT OF ENG COMPT)
FUSE BLOCK
FUSE LINK B
GROUND LEFT FRONT WHEEL SENSOR INPUT LEFT FRONT WHEEL SENSOR GRD
HOT AT ALL TIMES
HOT IN
HOT IN RUN, BULB TEST OR START
I/P INDIC FUSE
INSTRUMENT CLUSTER
LEFT FRONT WHEEL SPEED SENSOR
LT BLU WIRE
NCA WIRE
ORG/ WIRE
OUT
PCM/IGN FUSE 5
PNK WIRE
PUMP MOTOR
PUMP MOTOR POWER OUTPUT
REAR AXLE SPEED SENSOR
RED WIRE
RIGHT FRONT WHEEL SENSOR INPUT RIGHT FRONT WHEEL SENSOR GRD
RIGHT FRONT WHEEL SPEED SENSOR
RUN WIRE
SOLENOID VALVES
STOP LAMP SWITCH (ATTACHED TO BRAKE PEDAL BRACKET)
STOP/HZD FUSE
TAN WIRE
UNDERHOOD ELECTRICAL CENTER
VALVE POWER OUTPUT
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brake circuits -> CONTROL SIGNALS
